Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterFast, Reliable Gate Installation Across Calabasas
Gate installation in Calabasas runs $2,800 to $14,000 for most driveways, with custom ornamental double gates and underground operators on the higher end. We’re a locally owned, owner-operated company and Hal Gatewood’s name is on every job. Calabasas isn’t a place where you call a faceless franchise and hope for the best. The gates here are heavy, custom, often HOA-regulated, and they need to work every single time you leave for Mulholland or come home off the 101. Call (559) 314-7708 and a live person answers. That’s how it’s been since 2001.
Key Takeaways
- Typical driveway gate install in Calabasas: $2,800-$14,000 depending on size, material, and operator
- We handle HOA approval documentation for community entrances in The Oaks and other gated enclaves
- Free estimates. Price quoted and agreed before work starts. No trip charge inside the county.
- 90-Day Done Right Promise in writing on every installation
- Live person answers 24/7, not a voicemail or a call center
Why Gatewood Fence & Gate Is Calabasas’s Preferred Gate Installation Company
We’ve built gates in Calabasas for over two decades, and we know what happens when the wind comes through the pass between the Santa Monica Mountains and the Simi Hills. A gate that works fine in Woodland Hills gets hammered here. We account for that before we pour the first footing. Hal’s crew has installed and repaired gates in The Oaks, around Calabasas Lake, and along Las Virgenes Road, and the work holds up because we size posts and operators for what actually happens in this corridor, not what the manufacturer’s average assumes.
People in Calabasas don’t want a gate that just opens and closes. They want a gate that matches the house, works with their intercom and camera system, and doesn’t wake half the street when it cycles at 6 a.m. That attention to fit and finish is why homeowners in Calabasas call us back when they add a second gate or upgrade an old operator. Every job carries the 90-Day Done Right Promise, stamped in writing. If it’s not right, we come back and make it right. No runaround. And if you want to verify who you’re dealing with, our address and license number are published. Hal’s name is on the shop, and the shop is accountable.
Calabasas to Los Angeles isn’t a short drive, but we schedule locally and we show up in the window we promised. For repair calls, a person answers the phone around the clock and we get out to you fast. For installations, we measure on site, give you a written price, and stick to it.
Our Gate Installation Services in Calabasas
Calabasas gates tend toward the heavy end of the spectrum: custom scrollwork, big solid panels, hand-built frames. We install all of it, including Gate Installation from scratch or replacing an existing gate while reusing a good operator. Here’s what we do most often in Calabasas:
Driveway Gate
Most Calabasas driveway gates are ornamental iron, often 400 to 800 pounds per leaf. That weight wants a proper post footing, not a fence post. We dig deep, set with concrete, and size the hinges and operator for the actual panel weight. If you’re on Las Virgenes or in a hillside community with a longer run, we plan the conduit and power feed accordingly, so you’re not trenching your driveway twice.
Pedestrian Gate
Pedestrian gates in Calabasas often sit next to a larger driveway gate and get used ten times more often. That means the hinges, the closer, and the latch take real abuse. We install commercial-grade hardware even on smaller gates, because a pedestrian gate that sags or won’t latch is the one your HOA manager notices first.
Sliding Gate
Slide gates work well on flatter lots along Parkway Calabasas and around the lake, but they’re prone to derailing in wind events when debris collects in the track. We install cantilever slides where the lot allows it, and we always secure the rail and guide rollers for the wind gusts that funnel through this corridor. A slide gate that derails once will derail again unless the track and post are set right the first time.
Swing Gate
Swing gates are the signature Calabasas look. Ornate, hand-forged, double-panel. They also catch the most wind. We reinforce hinge posts and weld gussets where the original installer didn’t, and we match new sections to existing ironwork so the addition doesn’t look like an addition.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Trusted Brands We Service in Calabasas
We’re certified to work on nine major gate brands, and in Calabasas we mostly see Elite, FAAC, and LiftMaster on older estates, plus Mighty Mule on smaller ranch-style lots. We stock parts for all of them locally, so when an original 1990s Elite operator gives out, we’re not telling you to wait three weeks for something off the internet. We’ll swap in a modern LiftMaster or FAAC that integrates with your existing keypad and intercom, and we’ll do it on a schedule that respects your time.
Common Gate Installation Problems We See in Calabasas Homes
- Santa Ana wind damage. The wind corridor between the Santa Monica Mountains and the Simi Hills accelerates gusts and slams them into swing gates, bending panels and pulling hinge screws right out of the post. We reinforce the post with a deeper footing and add frame gussets on installs so the gate survives the next event. A gate that bent in a windstorm may also have cracked the post below grade, which is where we start looking.
- Aging original operators. Many Calabasas homes were built between the late 1980s and early 2000s, and the FAAC or Elite operators installed at build-out are now 25 to 35 years old. They fail by burning out or quitting mid-cycle, leaving a 600-pound gate stuck half open. That’s the point where someone always asks us to “just fix the opener,” and sometimes that’s right. Sometimes the operator outlived the gate frame, and the real fix is re-welding the panel and setting new hinges before a new operator goes in.
- Non-standard ornamental ironwork breaks. Calabasas estate gates are full of custom scrollwork, twisted pickets, and decorative rings that no parts catalog carries. When a section snaps or a hinge boss tears, off-the-shelf iron doesn’t match. We weld on site, so your gate stays in your driveway and we fabricate the matching piece rather than replacing a perfectly good panel.
- Post-Woolsey hardening requirements. Since 2018, HOAs and homeowners in the hillside areas bordering Calabasas have been specifying fire-rated wiring conduit, non-combustible intercom housings, and metal components even on repair jobs. If you’re in a community with new fire-safety codes, we handle the paperwork and the materials so the gate gets built to the standard your HOA files with the county.
Pricing for Gate Installation in Calabasas, CA
What you’ll pay depends on what you’re installing, but here’s what a Calabasas job typically runs. A single driveway swing gate with a basic operator starts around $2,800. A double custom ornamental swing gate with a new LiftMaster or FAAC operator and reinforced posts lands between $6,500 and $14,000. Pedestrian gates run $900 to $2,400. Slide gates sit in the $4,000 to $9,000 range. Underground operators add $1,800 to $3,500 because of the excavation and waterproof housing. Custom fabrication and matching existing ironwork is priced per piece, quoted before we start. Every estimate is free, in writing, and the price we quote is the price you pay. Nothing changes at the door.
For an exact quote on Gate Installation in Calabasas, call (559) 314-7708. We’ll come out, measure, and give you a number you can hold us to.
We Also Serve Cities Near Calabasas
Our crews work throughout the area, so if you’re in Topanga, Agoura Hills, Oak Park, or Westlake Village, we’ll come out and handle your gate the same way we handle a Calabasas install: measured, quoted, and built to last.
Serving Calabasas, CA - Our Local Coverage Area
We’re based in the Calabasas area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs - Gate Installation in Calabasas
Yes, most Calabasas HOAs require written approval for any gate that affects a community entrance, shared access road, or streetscape. The Oaks, The Oaks of Calabasas, and most other gated enclaves in the 91302 ZIP have architectural review committees that set material, height, and color standards. The approval process is usually 2 to 6 weeks. We’ve worked with enough Calabasas boards to know what they ask for - load calculations, finish specs, operator noise ratings - and we’ll prepare the submittal package so you’re not going back and forth with the committee for months. If you’re replacing an existing gate with a like-for-like match, many HOAs still want a written notice. Call (559) 314-7708 and we’ll walk you through what your specific community requires.
Yes, we match it. That’s one of the reasons we weld on site rather than ordering a pre-fabricated section from a catalog. Calabasas estate gates from the 1990s and early 2000s use a lot of custom scrollwork and twisted pickets that are no longer manufactured. We fabricate the matching section in the driveway, including the patina and finish, so the new addition reads as part of the original gate. Hal’s crew has matched more custom ironwork in Calabasas than any franchise will ever see. A gate that’s worth matching is a gate worth fixing properly, and that’s exactly what we do.
Usually both, and the post is where the real danger is. The wind catches the panel like a sail and the force transfers to the hinge post. You’ll see the panel bow or twist, but the post may have cracked below grade where you can’t see it. If we fix the panel without checking the post, the gate will sag again within a year. A gate sags in the hinge post, not in the middle. We dig down, inspect the footing, and if the post is cracked we replace it and pour a deeper, stronger footing before re-hanging the panel. In Calabasas, where the Santa Ana events come through the pass every fall, this is the single most common repair we do.
Yes, we install underground operators for swing gates, and we use sealed, watertight housings that can handle Calabasas’s winter rains. Underground operators are a clean look for Calabasas estates where the gate is the first thing you see and nobody wants a mechanical arm bolted to the face. The tradeoff is price - the unit plus excavation and waterproof housing runs $1,800 to $3,500 on top of a standard install - and maintenance access is tighter. For many Calabasas homeowners, the clean look wins. We’ll show you both options and give you a written price for each before you have to decide.
Since the 2018 Woolsey Fire burned through hillside areas bordering Calabasas, many HOAs and homeowners now require non-combustible gate components, fire-rated wiring conduit, and metal intercom housings on installation and even repair jobs. It’s a hardening mindset you don’t see as often in neighboring Woodland Hills or Agoura Hills. If your community adopted new fire-safety codes after 2018, we’ll spec the gate to match your HOA’s filed standards - that includes the conduit for the operator power, the intercom enclosure, and sometimes the hardware on the gate itself. We recently installed a custom ornamental double swing gate for an estate in The Oaks, matching the existing wrought-iron scrollwork to the original 1990s design. The old Elite operator had burned out after years of Santa Ana debris, so we replaced it with a new LiftMaster and buried fire-rated conduit for the intercom and loop detector, ensuring smooth, silent operation even during wind season.
Call Gatewood Fence & Gate for Gate Installation in Calabasas
If you need a gate installed, replaced, or built out in Calabasas, call (559) 314-7708. A live person answers, day or night. We’ll come out, look at what you have, and give you a written price before any work starts. Hal Gatewood has been doing this since 2001, and the 90-Day Done Right Promise means you never have to chase anyone down. No voicemail, no call center, no games. Just a gate that works, built by people who will answer the phone when you call.
Written by Hal Gatewood, Owner at Gatewood Fence & Gate, serving Calabasas since 2001.